GE Monogram ZET9550SHSS Bedienungsanleitung PDF herunterladen (Seite 4)

2 E

SECURING UPPER MICROWAVE/ADVANTIUM OVEN

TO CABINET

For double oven with microwave or Advantium upper ovens. Secure a wooden cleat to side of

cabinet so that the upper oven can be secured to the cleat with provided screws

27” Cabinet requirements

• No shims (or cleats) required when cabinet is in

minimum width condition.

• If cabinet is at maximum width condition, add wood

shims to bring cabinet to minimum condition.

30” Cabinet requirements

• No shims (or cleats) required when cabinet is in

minimum width condition.

• If cabinet is at maximum width condition, fix the wood

cleats as shown in illustration.

2 F

CUTOUT FOR INSTALLATION OVER A

WARMING DRAWER

NOTE: Install the oven only with specific models listed on the label located on top of the oven.

NOTE: Additional clearances between cutouts may be required. Check to be sure the oven

supports above the Warming Drawer location do not obstruct the required interior depth and height.

When installing a Warming Drawer below a single, double, or combination oven, a separate

120V, 60 HZ, properly grounded receptacle must be installed. Refer to installation instructions

packed with the Warming Drawer for specific installation requirements.

Anti-Tip Block Against

Rear Wall Per Warming

Drawer Requirement

2" (5.1 cm)

Min.

Per Warming

Drawer

Requirement

Continue to Section 3 for Double Wall Oven with Pedestal. Otherwise, continue to Section 4.

3 A

DETERMINING WHEN TO USE THE PEDESTAL

(30” DOUBLE OVENS ONLY)

WHEN TO USE THE PEDESTAL

When replacing an older GE Appliances 30” double wall oven with a new GE Appliances model.

Cutout height = 51-13/16” to 51-15/16”. This is our traditional cutout height.

WHEN NOT TO USE THE PEDESTAL

When replacing a 30” double wall oven from another manufacturer (ie. Whirlpool) with a new

GE Appliances 30” double wall oven. Cutout height = 50-1/4”. You will need to verify that the

existing cutout matches the 50-1/4” dimension.

If the new GE Appliances 30” double wall oven is being installed into new construction (ie. not a

replacement), then the recommended installation is to use the Pedestal.

3 B

PEDESTAL RAIL INSTALLATION

(30” DOUBLE OVENS ONLY)

A. Position the pedestal rails with the top cutout toward the front of the opening and the flanges

on the bottom, pointing toward the center. Locate each rail on the floor or cabinet runner,

slightly inward from the side of the cabinet. Make sure the front of each rail is not protruding

beyond the front of the cabinet opening.

B. Drill pilot holes and attach rails to runner or bottom of cabinet with provided hardware.

Flanges toward

center of cutout

Top cutout

toward front

Attachment

screws

6.375”

27.5”

1.5”

3.0”

Cleat locations on 30” cabinet

with maximum cutout condition

Wood Cleats

1 2 3 4 5 6 7 8 9 ... 15 16

Kommentare zu diesen Handbüchern

Keine Kommentare

GE Monogram ZET9550SHSS Bedienungsanleitung Seite 4

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein GE Monogram ZET9550SHSS