GE Monogram ZET9550SHSS Bedienungsanleitung PDF herunterladen

BEFORE YOU BEGIN

Read these instructions completely and

carefully.

•

IMPORTANT — Save these

instructions for local inspector’s use.

•

IMPORTANT — Observe all

governing codes and ordinances.

• Note to Installer – Be sure to leave these

instructions with Consumer.

• Note to Consumer – Keep these

instructions for future reference.

• Skill level – Installation of this appliance

requires a qualified installer or electrician.

• Proper installation is the responsibility

of the installer.

• Product failure due to improper installation

is not covered under Warranty.

• Product is for indoor use only.

Installation Instructions

27” & 30” Electric Built-In Wall Ovens

FOR YOUR SAFETY:

WARNING

Before beginning the installation, switch power off at the service panel and lock

the service disconnecting means to prevent power from being switched on accidentally. When the

service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a

tag, to the service panel.

Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure. Weight

on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb, sit,

stand or hang on the oven door.

Make sure the wall coverings, counters and cabinets around the oven can withstand the heat (up to

200°F [93.3°C]) generated by the oven.

MATERIALS YOU MAY NEED

Junction Box

Wire Nuts

Strain Relief Clamp for 1/2” Conduit

36” (91 cm) of String

TOOLS YOU MAY NEED

1/8” Drill Bit and Electric or Hand Drill

T20 Screwdriver

Phillips Screwdriver

Wire Strippers

7/16” Nut Driver (combination ovens)

1/4” Nut Driver (30” combination ovens)

REMOVE PACKAGING MATERIALS

Failure to remove packaging materials could result in damage to the appliance. Remove all

packing parts from oven, racks and heating elements. Remove protective film and labels on

the outer door and control panel. Also, remove plastic on trims and panel, all tape around the

oven and any shipping screws securing the oven to the base pad. Open oven door and remove

literature pack and oven racks. Remove the bottom trim from the top of the oven. It will be

installed at the end of the installation process. The trim is wrapped separately and taped to the top

of the unit. Remove pedestal rails from separate box and set aside (30” Double Wall Ovens Only).

PREPARE THE OPENING

NOTE: If the cabinet does not have a solid

bottom, two braces or runners must be

installed to support the weight of the oven.

For single ovens, the runners and braces

must support 220 lbs (99 kg). For double and

combination ovens, the runners and braces

must support 400 lbs. (181 kg).

NOTE: If marks, blemishes or the cutout

opening are visible above the installed oven,

it may be necessary to add wood shims

under the runners until the marks or opening

are covered.

NOTE: If the cabinet does not have a front

frame and the sides are less than ¾” (1.9 cm)

thick, shim both sides equally to establish the

cutout width.

ATTENTION INSTALLER: All electric wall ovens must be hard-wired (direct-wired)

into an approved junction box. A plug and receptacle is NOT permitted on these products.

DESIGN INFORMATION

SINGLE OVEN INSTALLATIONS

The single oven may be installed in a cabinet alone or above a warming drawer. The single oven

may also be installed side by side, below a countertop, or below specified cooktops. See the label

on top of the oven for approved models.

DOUBLE AND COMBINATION OVEN INSTALLATIONS

A double or combination oven may be installed in a cabinet alone or above a warming drawer.

See the label on top of the oven for approved models.

IMPORTANT: Always refer to individual installation instructions packed with each product for

specific requirements.

Questions? Call GE Appliances at 1.800.GE.CARES (1.800.432.2737) or visit

www.GEAppliances.com. In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca.

Suitable

Bracing

to Support

Runners

2" x 4" (5 cm x 10 cm)

or Equivalent Runners Level

with Bottom of Cutout

and Flush with Sides of Cutout

1 2 3 4 5 6 ... 15 16

Inhaltsverzeichnis

Seite 1 - Installation Instructions

BEFORE YOU BEGINRead these instructions completely and carefully.• IMPORTANT — Save these instructions for local inspector’s use.• IMPORTANT — Obse

Seite 2 - SIDE VIEW

2 B ABERTURA PARA HORNOS ÚNICOS – BAJO EL MOSTRADOR DE ENCIMERANOTA: Estos hornos sólo pueden instalarse bajo los modelos específicos como se indica

Seite 3 - 31-11109 05-17 GEA

2 C ABERTURA PARA HORNOS DOBLES (2 HORNOS TÉRMICOS)NOTA: Si el gabinete no cuenta con un armazón frontal y los lados son menores a un grosor de 3/4”

Seite 4

2 F ABERTURA PARA INSTALACIÓN SOBRE UN CAJÓN CALENTADORNOTA: Instale el horno sólo con los modelos específicos listados en la etiqueta ubicada en la

Seite 5 - ELECTRICAL REQUIREMENTS

4 A REMOCIÓN DE LA PUERTA (RECOMENDADO PARA HORNOS TÉRMICOS)ADVERTENCIA La puerta del horno microondas en un horno combinado nunca debe ser retirada,

Seite 6 - MAKE ELECTRICAL CONNECTIONS

5 REQUISITOS ELÉCTRICOS (CONT.)Este aparato debe recibir el voltaje y frecuencia adecuados, y debe conectarse a un circuito derivado individual con ad

Seite 7 - SLIDE OVEN INTO OPENING

10 A INSTALE LOS TORNILLOS DE MONTAJE (HORNO SUPERIOR EN HORNOS COMBINADOS)• Deslice el horno por la distancia que falta dentro de la abertura para

Seite 8 - BOTTOM TRIM INSTALLATION

13 REEMPLAZO DE LA PUERTA TÉRMICA DEL HORNONOTA: La puerta del horno es pesada. Puede necesitar ayuda para levantar la puerta lo suficiente como para

Seite 9 - Instrucciones de instalación

2 A CUTOUT FOR SINGLE OVENS IN WALL CABINETNOTE: If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim both

Seite 10 - Instalaciones lado a lado

2 C CUTOUT FOR DOUBLE OVENS (2 THERMAL OVENS)NOTE: If the cabinet does not have a front frame and the sides are less than ¾” (1.9 cm) thick, shim bot

Seite 11 - MICROONDAS SUPERIOR)

2 E SECURING UPPER MICROWAVE/ADVANTIUM OVEN TO CABINETFor double oven with microwave or Advantium upper ovens. Secure a wooden cleat to side of cabin

Seite 12

4 A DOOR REMOVAL (RECOMMENDED FOR THERMAL OVENS)WARNING The door for the microwave oven on a combination oven should never be removed, unless by a ce

Seite 13 - ADVERTENCIA

6 MAKE ELECTRICAL CONNECTIONSWARNING Switch power off at the service panel and lock the service disconnecting means to prevent power from being switc

Seite 14

10 B INSTALL MOUNTING SCREWS (THERMAL OVENS)WARNING Mounting screws must be used. Failure to do so could result in the oven falling out of the cabine

Seite 15

13 REPLACING THE THERMAL OVEN DOORNOTE: The oven door is heavy. You may need help lifting the door high enough to slide it into the hinge slots. Do no

Seite 16

ANTES DE COMENZARLea estas instrucciones por completo y con detenimiento. • IMPORTANTE – Guarde estas instrucciones para el uso de inspectores local